Skip to content

Signing in

Your account page shows every GridWatchdog unit whose main alert address is yours, with its power, backup power and signal. There’s no password: we email you a link, and the link signs you in.

  1. Go to my.gridwatchdog.com/account.
  2. Enter the main alert address of your units, and select Email me a sign-in link.
  3. Open the email called Your GridWatchdog sign-in link and select Sign in.
  4. The page that opens asks you to confirm. Select Sign in again.

Some email services open every link in a message to check it for safety. The second Sign in makes sure a person finishes signing in, not the scanner.

  • A sign-in link works for 7 days.
  • After you sign in, you stay signed in on that browser for 30 days.

When you sign in from a link, we mark your address as confirmed on each unit whose main alert address it is, if it isn’t confirmed already. Your units send outage alerts whether or not you’ve confirmed; confirming only proves that our emails reach you.

Every unit with the same main alert address appears on one account page. A unit whose main address is different isn’t shown. Sign in with that address to see it.

After you ask for a link, you always see the same Check your email page. We never say whether an address has units on it, so that page can’t tell you if something went wrong. If no email arrives:

  • Look in your spam or junk folder. Our emails come from alerts@gridwatchdog.com.
  • Wait before asking again. We send at most one sign-in link to an address every 5 minutes. If you ask again sooner, you’ll see the same page, but no new email is sent. Use the link from the first email.
  • Don’t retry too often. From one internet connection, you can make up to 8 sign-in requests in 15 minutes. After that, requests are ignored until the 15 minutes are up.
  • Check the address on the unit. A unit alerts the address typed when it was set up, or the one it was changed to later. If it was changed, sign in with the new address. If the address was mistyped at setup, no sign-in link can reach you, and neither can your alerts. Email support@gridwatchdog.com with the ID printed on your unit.

The page that opens tells you why:

  • The link is incomplete. Some email apps break long links across lines.
  • The link has expired.
  • The link isn’t valid. This usually means it was copied by hand.

In each case, select Send me a new link and start again. If your browser is already signed in to the same account, an old link just opens your account page. If it’s signed in with a different address, the page tells you which one.