Skip to content

Filtered mode

Some circuits flicker: the power drops and comes back several times in a short spell. An email for every one of those would bury the alerts that matter, so when the power at a unit keeps flickering, GridWatchdog switches that unit to filtered mode.

Filtered mode is off to begin with, and every outage is emailed straight away. It turns on by itself when a unit loses power 3 times within 60 minutes.

The power-out email for the outage that turns it on is still sent straight away. It has a notice at the end of the message, Filtered mode is now on, so you know what has changed.

When the power goes out, we wait before emailing you:

  • If the power stays out for about 1 minute, we send the power-out email then. You get the power-restored email as usual when the power comes back.
  • If the power comes back sooner, we don’t email you about that outage at all: no power-out email and no power-restored email.
  • If the power comes back just as the wait ends, before the power-out email has gone out, you get only the power-restored email. It says when the power went out and for how long.

Every outage is still recorded in the unit’s history, whether or not we emailed you about it.

Filtered mode switches itself off 24 hours after the last burst of flickering. From then on, outages are emailed straight away again.

If you’d rather hear about every outage, however brief:

  1. Open the unit’s Alert settings page. It’s linked from the unit’s card on your account dashboard, and from the email that turned filtered mode on (Alert me on every blip instead).
  2. Choose Alert me on every blip instead.

This turns filtered mode off straight away, and it won’t turn itself on again for that unit. If an outage is being held when you do this, we send its power-out email straight away. Very short interruptions are still ignored; see How fast alerts arrive.

To switch back, open the same Alert settings page and choose Let the filter turn on automatically.

If the power at your unit flickers a lot, support can set a filter on it by hand, for example with a longer wait. Email support@gridwatchdog.com to set one up or change it.