Skip to content

How fast alerts arrive

When the power goes out, you’ll typically get an email about 20 seconds later. When it comes back, the power-restored email usually follows within a minute.

The moment mains power drops, your GridWatchdog switches to its built-in power reserve and reports the outage over its own cellular connection. We send your power-out email as soon as that report reaches us; we don’t wait for a scheduled check.

From the outage to the email landing in your inbox typically takes about 20 seconds. That covers the unit confirming the outage is real, sending the report over the cellular network, and your email provider delivering the message.

Interruptions shorter than 5 seconds are ignored. The unit doesn’t treat them as outages, so they aren’t emailed and don’t appear in its history.

A weak signal or a busy cellular network can stop the first report from getting through. The unit tries again, up to 4 times in total, typically over the next couple of minutes. After that it keeps trying only while its backup power lasts, which is a few minutes. As soon as a report gets through, we send your power-out email.

If no report gets through before the backup power runs out, you won’t get a power-out email while the power is out. This can happen with a bad signal, or when the local cellular network is down too. The unit goes quiet until the power comes back. We notice that the unit has stopped checking in and email you about that instead. See No Signal and Went Dark emails.

Mains power coming back wakes the unit straight away. It reconnects, reports that the power is back, and we send the power-restored email, including how long the power was out, as soon as the report arrives. This usually takes less than a minute.

  • Filtered mode is on. If the power at the unit has been flickering, we wait about 1 minute before emailing about an outage, and don’t email at all if the power comes back within that time. See Filtered mode.
  • The outage was over before it was reported. If the power comes back before any report got through, we don’t send a power-out email for an outage that has already ended. The unit reports it afterwards, and it appears in its history.

In both cases you won’t get a power-restored email either, because you were never told the power went out.

Once we’ve sent an email, how quickly it lands is up to your email provider. If alerts arrive late or not at all, see Not getting emails.