Setup problems
If activation doesn’t work, the setup page shows Activation Failed and a message saying why. Find the message below.
Activation messages
Section titled “Activation messages”- No SIM card detected. Insert the SIM and try again. The unit can’t find its SIM card. Email support with the ID printed on your unit.
- Cellular not connected. Check SIM and signal. The unit couldn’t connect to a cellular network. Move it to a spot with better signal, such as near a window or higher up, and try again. See Where to put it.
- Could not open a secure connection to the cloud. Check signal, then try again. The unit connected to the cellular network but couldn’t reach us securely. This is usually a weak signal. Try again, or try a better spot.
- This SIM isn’t supported by GridWatchdog. Contact support. Email support with the ID printed on your unit.
- Already activated. The unit is already set up. To set it up again, you need to factory reset it first.
- Name or Email messages: what you typed can’t be used. Names and addresses can use ordinary letters, numbers and punctuation, but not accents, emoji or the characters < > and “. A message saying a name or address is too long tells you the limit.
- Cloud registration failed. Try again. Something went wrong on our side or along the way. Wait a minute and try again.
If the page says The device did not answer, activation may still be going. Wait a minute, then reload the page. If the unit finished activating, you’ll see its status page instead of the setup form.
If a message keeps coming back, email support@gridwatchdog.com with the ID printed on your unit and the exact message.
Factory reset
Section titled “Factory reset”A factory reset erases the unit’s name and email address, so you can set it up again from the start.
- Make sure the unit is plugged in and has power.
- Press and hold the BOOT button. After a few seconds the screen shows FACTORY RESET in with a countdown.
- Keep holding for 10 seconds in total, until the countdown ends. The unit restarts and shows SETUP REQUIRED.
- Set it up again; see Set up your device.
To cancel, let go before the countdown ends.
Use BOOT for this, not the button marked RST. RST only restarts the unit and doesn’t erase anything.
If you set the unit up again with a different email address, the old address gets an email saying the unit was set up with a different email, and stops getting its alerts. Any backup contact is removed.