No Signal and Went Dark emails
Your GridWatchdog checks in with us regularly over its own cellular connection. The emails on this page mean those check-ins have stopped. They tell you we’ve lost contact with the unit, which doesn’t always mean your power is out.
No Signal
Section titled “No Signal”We send No Signal when a unit stops checking in. It tells you we’ve lost contact, not whether your power is on.
On mains power, a unit normally checks in every 30 minutes. No Signal usually arrives within an hour: once a check-in is overdue by 10 minutes, we send it.
Still Not Reporting
Section titled “Still Not Reporting”If the unit still hasn’t checked in about 4 hours after the No Signal email, we send Still Not Reporting. Its subject line says how long the unit has been silent.
Device Went Dark
Section titled “Device Went Dark”We send Device Went Dark when a unit that told us your power was out stops checking in.
If it goes about 2 hours without checking in, we send Device Went Dark. The email gives the backup power level we last heard. Your power may still be out; we just can’t tell any more.
When the power comes back and the unit reports it, you’ll get Power Restored.
Back Online
Section titled “Back Online”We send Back Online when a unit we sent No Signal about checks in again and its power is still on. You don’t need to do anything.
What to check
Section titled “What to check”- Look at the unit’s screen.
- POWER ON, with signal bars, a network name and OK on the line below: the unit is working and its last check-in got through. The problem was probably temporary.
- !! in place of OK: its last check-in didn’t get through. If few or no bars are filled, the signal is weak where the unit is.
- Confirm email on the line below POWER ON: you haven’t confirmed your address yet. See Signing in.
- POWER OUT: the unit isn’t getting mains power. Check the plug and the outlet.
- LOW ENERGY: its backup power ran low during an outage, and the unit is sleeping until the power comes back.
- A blank screen: plug the unit into an outlet you know works. If the screen stays blank, contact support.
- Check the signal where the unit sits. Cellular signal is weakest in basements, inside metal cabinets and behind large appliances. Try a spot near a window or higher up, on an outlet that stays powered. Your account page shows the last signal reading we received.
- Check our service status. If the problem is on our side, the Service status link at the bottom of your account page shows it.
If it keeps happening, email support@gridwatchdog.com with the ID printed on your unit.